Machine Down!!

[Ger21]

Typically, S1 and DCM would go to a relay, with the relay closing the circuit between them.


Not sure what they were doing with S3-S5?

My recommendation would be the UC300ETH with a UB-1 breakout board from CNC Room, but it's not cheap. Very easy to wire up, though.
https://www.cncroom.com/interface-cards/uc300eth-ub1

[dougie8]

Hi all,

First of all thanks to all who have replied to my post your help is greatly appreciated.

I am about to order the UC400ETH along with the UCCNC software, however as I will also need to upgrade the breakout board I have found this to be a bit of a headache due to the options available. I have found the following three all on various websites can anyone recommend a BOB that will be compatible, and what the difference is between a £10 board to a £50 board?

CNCDrive

CNC4You

eBay

I have also found on Stoney CNC using the HDBB2 board (see attached), as they are UK based presumably they would arrive before Christmas, Ideally I would like to get the machine up and running again during the holidays.

Thanks again
Dougie

[Ger21]

The UCBB board will NOT work with the UC400ETH. It also doesn't have analog speed control, which you probably need for the spindle.

A $10 breakout board is the cheapest you can get from China.
In some cases, a $50 breakout board is the same board, but imported, sold and supported by a reseller.
In other cases, it will have more features.

[dougie8]

Hi all,

Thanks for everyones previous replies, I never managed to get my router upgraded as per my previous posts as I managed to grab a hold of an old XP pc which got me up and running again with NCStudio.

Sadly this has now given up the ghost (I think the dampness in my garage is killing the pc's) and I'm now back to where I was before Christmas with a router that is now not working. I have been saving up my pennies for this day to come and have now decided its time to bite the bullet.

I have spotted the following on CNCDrive which is on special offer with a UCCNC licence included:

http://www.shop.cncdrive.com/index.php?productID=965

Can someone advise if this would be suitable for my machine?

I have a spare Windows 10 pc lying around which has not too bad a spec, other than a new PSU for the controller, what would I require to get my machine back up and running?

Has anyone any knowledge of this controller, is it fairly easy to setup and get running?

If anyone has any other suggestions I am open to ideas, obviously price dependant.

Thanks again

[Ollie78]

I have the UC300 eth from them and find it very good. It was easy to set up for me as a novice in CNC.

I had a PC disaster immediately after getting my second hand machine, lost all software and settings. That is when I decided to go with an ethernet motion controller. Uccnc works on a low spec pc very well for me.
Those new contollers with built in BOB look like a neat solution, seems like a bargain with free software licence. Similar idea to this one https://www.cncroom.com/interface-ca...igo249ia6r2v25
but much cheaper.
Just looked at the PDF http://www.cncdrive.com/downloads/AXBB_E_manual.pdf and it looks like the same setup as the uc300.

Good luck

Ollie

[Ger21]

Yes, the AXBB should work fine for you.
I have one, but haven't used it yet.