Thread: z axis probe connection
Threaded View
-
30-11-2018 #1
Hello my first post so please be gentle. I wish to fit a z axis probe to my newly acquired ancient Chinese 3020 mill, I am running mach3 and the controller has the yoocnc t62-3ax board. I have got it working by connecting the probe directly to pin 15 of my parallel port plug on the computer and allocating it in the software, it works ok but I suspect I need to isolate it somehow.
any help gratefully appreciated
John
Thread Information
Users Browsing this Thread
There are currently 1 users browsing this thread. (0 members and 1 guests)
Similar Threads
-
Which Connection ?
By manofgresley in forum Stepper & Servo MotorsReplies: 17Last Post: 13-07-2020, 01:55 PM -
Edge Probe + tool length probe on same input
By Noplace in forum General ElectronicsReplies: 1Last Post: 18-06-2016, 11:12 AM -
CSMIO-M Tool Probe Connection - +24v to earth
By Noplace in forum CS-Lab (CSMIO)Replies: 1Last Post: 10-04-2016, 09:17 PM -
Or Guidance ;) Connection Name(s)
By Carlb1058 in forum Marketplace DiscussionReplies: 6Last Post: 13-07-2013, 12:48 AM -
ghost in the x axis - bad electrical connection
By jonm in forum General ElectronicsReplies: 5Last Post: 11-04-2010, 08:31 PM
Bookmarks