setting axis A in spindle mode

[magicniner]

If you make 6mm holes for switch access you can make neat little Top-Hat shaped buttons to fit from the inside of the case prior to fixing the pulse generator, it makes the job neat, the buttons easy to access and leaves no ingress for chips and muck.

[Sven]

It can be done but it is not that easy.

A friend helped me setting up my 4th axis to run in index as well as spindle in linuxcnc, the latter demonstrated here:

[magicniner]

It can be done but it is not that easy.

Changing the motion controller to one which supports the use of a rotary axis as a spindle works huh?

I left my surprised face at home! :D