Thread placement and plea for help

**Chaz** · 12-12-2018

Originally Posted by Wobblybootie

Hi folks,

I want to start a thread re: a machine I have acquired

It is a 3Axis mill designed to mill Orthotics but was being scrapped (too long a story for here).

My questions will mainly be Electrical based ...

So which sub forum to gain most coverage/knowledge??

Cheers

Tim

Hi and welcome. There is a general area or DIY one like this - http://www.mycncuk.com/forums/253-DIY-Router-Build-Logs - im sure the Mods will help move if its in the wrong area.

**Wobblybootie** · 12-12-2018

Cheers Chaz, I'll stick it into general and see what transpires.

**routercnc** · 12-12-2018

Hi Tim

Welcome back to the forum again!

Either the sections from Chaz or look on the main page for the electrical tab. The electrical system you want to ask about might already have its own area in there or there is a general electrical area.

**Wobblybootie** · 12-12-2018

Thanks, I may try stuffing it into the Machine discussion section as the damn thing is a bit of a puzzle and a challenge at the same time. I may get more responses re the machine first then the sparky smoky bit ...