Your opinion on these

[CocasDaNeve]

Ok, so after a thorough internet search (where I was surprised that the motors were consistently considerably more expensive than the drivers), here is what I came up with:
M-2330-FH - 200 euros
M-2330-XH - 200 euros
M-2330-FH - 200 euros (without the gearbox)
M-2348-FH - 275 euros (including the brake)
SST-1500 - 120 euros each
TG-540 - 50 euros each
NC-540 - 50 euros

SSt-3PS12-75 75V supply - unless someone buys everything and asks for it I'll keep it.

Or 1500 euros for the lot. I would prefer selling everything together, this way the wiring looms that connect all the parts are included and I don't have to cut anything.

All the motors have 8,000 counts/rev sensors attached.

The prices are slightly below the average of the minimum and maximum I've found, I didn't go to the lowest price because I reckon these are in as good a state as an used servo can be, moving the small robotic manipulator they were subjected to minimal loads and they worked inside a machine that filtered the intake air for cooling, so no dust inside for the most part.

What do you guys think?