Thread: Weiss VM32 Mill Conversion
Threaded View
-
06-02-2019 #6
Y axis start.
Picture 1 original X Y acme screw nuts
picture 2 Ballscrew mounts on saddle. These are 15mm thick (from scrapbox) but 12mm should work.
picture 3 Saddle with nut fitted. To fit to the mill base the mounts/nut must be removed from the saddle to the keeper(post 3 picture 7). After screw is located into the base, the nut and mounts can be attached. The keeper has a 10mm recess to fit the turned down end of the ballscrew to give alignment. The saddle can then be fitted and attached to the mounts with original 8mm screws.
picture 4 Y axis ballscrew mounts
picture 5 Y axis top view. All y axis parts are 10mm mild steel.
picture 6 Y axis plate dimensions.
picture 7 Y axis sides for motor mount. Length may be altered depending on coupling ans shaft lengths.
Thats it for now
Best Regards
picclockLast edited by picclock; 06-02-2019 at 12:29 PM.
Thread Information
Users Browsing this Thread
There are currently 2 users browsing this thread. (0 members and 2 guests)
Similar Threads
-
Sieg/ARC X3 CNC mill conversion
By Leadhead in forum Workshop & EquipmentReplies: 4Last Post: 20-10-2018, 04:11 PM -
Weiss WMD25LV mill
By Bill K in forum Milling Machines, Builds & ConversionsReplies: 4Last Post: 29-06-2014, 12:52 PM -
CONVERSION: Sx3 mill conversion
By dazza in forum Conversion Build LogsReplies: 1Last Post: 29-04-2014, 10:23 AM -
X3 Vs AMD 25LV (Weiss WMD 25LV) for CNC conversion
By sebring115 in forum Milling Machines, Builds & ConversionsReplies: 1Last Post: 18-11-2011, 12:20 PM -
Mill conversion to cnc
By wolsey in forum General DiscussionReplies: 1Last Post: 15-08-2011, 11:07 PM
Bookmarks