How do you wire a probe when using Miso-m smoothstepper

[Chaz]

There is an option to assign any input as probe. If you follow the CS Labs manual, it will show how. You can then select the correct input / pin in Mach 3's menu system under ports and pins (or pins and ports), dont remember which.

[terry1956]

Thanks for getting back, I must be thick, it talks about tool measurement probe but gives know detail how to wire it.

[Chaz]

Thanks for getting back, I must be thick, it talks about tool measurement probe but gives know detail how to wire it.

The wiring and port / pin assignment is all in the CS Labs manual.

Assuming you have installed the system, this should be easy to sort. If not and you are trying to add a probe with no knowledge, it might be tricky.

I can give you a call and explain roughly how it works, let me know if this will help.