CNCDrive AXBB super deal?

[Doddy]

Hi all,
For only €129.-

+ it has UCCNC included.

I would say most people can do all they need with this board?

Any thoughts?

Grtz Bert.

Verstuurd vanaf mijn SM-A320FL met Tapatalk

Indeed, a fine looking board. I can't find any reference to anything other than UCCNC. Is this a proprietary interface for UCCNC or are there similar drivers for Mach as for the other UCx00 interfaces?

[driftspin]

Indeed, a fine looking board. I can't find any reference to anything other than UCCNC. Is this a proprietary interface for UCCNC or are there similar drivers for Mach as for the other UCx00 interfaces?

Hi Doddy,

I am not sure, but the manual does not mention mach.



I am looking into some stuff for a friend who wants to build a 3axis router +/- 1000x1500x200 mm with twin x-axis ballscrews.



He has no software yet, so this is a very good looking board / software to start.


Grtz Bert.

Verstuurd vanaf mijn SM-A320FL met Tapatalk

[A_Camera]

Indeed, a fine looking board. I can't find any reference to anything other than UCCNC. Is this a proprietary interface for UCCNC or are there similar drivers for Mach as for the other UCx00 interfaces?

I have their UC300 controllers (have one for USB and one for ETH) and they both support Mach3 as well. If this new one is going to have drivers for Mach 3 or not, I have no idea, but CNC Drive have a pretty good support forum where you can ask that.

In fact, I just had a quick look, and there is an answer already to the same question:

http://www.forum.cncdrive.com/viewtopic.php?f=22&t=1834

Otherwise everything is proprietary, as far as I know, there are no generic controllers, and also in my experience, UCCNC is better than Mach3.

[driftspin]

I have their UC300 controllers (have one for USB and one for ETH) and they both support Mach3 as well. If this new one is going to have drivers for Mach 3 or not, I have no idea, but CNC Drive have a pretty good support forum where you can ask that.

In fact, I just had a quick look, and there is an answer already to the same question:

http://www.forum.cncdrive.com/viewtopic.php?f=22&t=1834

Otherwise everything is proprietary, as far as I know, there are no generic controllers, and also in my experience, UCCNC is better than Mach3.

Hi A_Camera,

Good find.

CNCdrive really supports their customers right.

Grtz Bert.

Verstuurd vanaf mijn SM-A320FL met Tapatalk

[A_Camera]

Indeed, a fine looking board. I can't find any reference to anything other than UCCNC. Is this a proprietary interface for UCCNC or are there similar drivers for Mach as for the other UCx00 interfaces?

In the meantime, during the night, they have released the driver for Mach3.

http://cncdrive.com/AXBB.html

[Ger21]

I bought one to use as a test setup for my desk to be used when developing custom screens and macros. Still waiting on some other components, but it's a really nice package.