. .

Hybrid View

Previous Post Previous Post   Next Post Next Post
  1. 27-03-2019 #1
    magicniner's Avatar
    Lives in Rotherham, United Kingdom.
    magicniner
    Last Activity: 05-05-2024 Forum Superstar, has done so much to help others, they deserve a medal. Has been a member for 9-10 years. Has a total post count of 2,021. Received thanks 230 times, giving thanks to others 42 times.
    I've been very methodical and worked through all the steps required to properly commission the Syil X7, this week finally got around to cutting some chips.
    This video shows a bit of the machining of the 80mm square pocket in a 316L Stainless plate -



    https://youtu.be/SvzSgXN-YW4

    The noise levels were very reasonable and standing outside my workshop it was hardly noticeable above background noise, I'm sure there is plenty of spare power and rigidity but I'll creep up on that as I do more cuts.

    I programmed the pocket 80.2mm square for my 80mm square tombstone offcut, the offcut seated firmly with a few blows from a soft faced hammer and now my Gerardi tombstone has a Mini Me ;-)

    Click image for larger version.  Name: 80mmSqPocketPurpose.jpg  Views: 508  Size: 117.5 KB  ID: 25580
    Last edited by magicniner; 27-03-2019 at 01:58 PM.
    You think that's too expensive? You're not a Model Engineer are you? :D
    Reply With Quote Reply With Quote

  2. The Following 3 Users Say Thank You to magicniner For This Useful Post:

    komatias, Lee Roberts, sletowslegran
« Previous Thread | Next Thread »

Thread Information

Users Browsing this Thread

There are currently 1 users browsing this thread. (0 members and 1 guests)

Similar Threads

  1. Mach3 and returning to cut position
    By dfox1787 in forum Artsoft Mach (3 & 4)
    Replies: 13
    Last Post: 07-07-2018, 10:06 AM
  2. Looking for a trainee position as a cnc operator
    By reefy86 in forum General Discussion
    Replies: 6
    Last Post: 07-06-2018, 08:19 PM
  3. Spindle position sensor
    By GeoffV in forum Motor Drivers & Controllers
    Replies: 3
    Last Post: 23-03-2014, 10:00 PM
  4. Position feedback
    By D.C. in forum Electronic Project Building
    Replies: 4
    Last Post: 17-10-2012, 11:30 AM
  5. router jumping position
    By johngoodrich in forum Linear & Rotary Motion
    Replies: 9
    Last Post: 23-09-2011, 06:31 PM

Bookmarks

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  

Forum Rules