Does it matter?

[A_Camera]

Hello, I got a question about choosing a breakout board for my cnc. I bought a uc300eth motion controller, along with 3 dm542t drivers, now I just need the breakout board. I've seen a lot of 5 axis boards that are relatively cheap, but they say they're for Mach 3. My problem is that I can't actually find any boards for Uccnc instead of for Mach 3/4. Does it actually matter though? Are breakout boards specifically configured to a single software somehow? Or can I use a Mach 3 breakout board for Uccnc? I understand that motion controllers are specifically configured to their own software (ie- Uccnc won't work on a warp 9 smoothstepper since smoothstepper is configured to Mach 3/4). But is this the same case for breakout boards???

Thanks in advance!!!!!

Sent from my Moto G (5) using Tapatalk

It doesn't matter if the eBay seller lists it as "Mach3" BOB. I am using this one (have two in my machine):



It is the same type as driftspin above uses. It costs less than $10 and it works well since I bought mine over two years now.

Anyway, UCCNC requires the use of controllers from CNC Drive.