Poles? Hah! Nope. So we tried to extrapolate the poles from the auto-tuning info in the manual / part of the initial setup procedure and the best we can ascertain is 2...but unless you can enter the |24,000" it won't accept the value, resting at 4 poles and that doesn't work. Motor gently starts to heat up.
I'd read on somewhere that you can enter "alternate" values with a sub-division of the motor speed, i.e. a value that would be accepted but that hasn't worked. It has to be programmed in!
If the spindle is one of the type that is generally used on here (2.2kw) then they are 2 pole so go to section 5.1 in the manual and look at F804 it is set to 4 change that to 2.

The speed is altered by changing the frequency so in my opinion (hopefully others with better knowledge will check) F111 should be 400 F112 should be about 120 .
F802 about 230 F803 what the motor current max is about 5 F114 about 3 F115 about 3

I think that F805 might be 3000

Please try and stick to facts as the waffle clouds them.

Change these at your own risk.