Skyfire cnc's

[Snapper]

What machine do you have and with what extras?

SVM2-VMC new July 2018
10k spindle with ceramic bearings
3.7kw spindle motor (currently hooked up to 2.2kw VFD for single phase, also have 4kw VFD for 3 phase input)
12 station ATC
Adtech 5 axis capable control with rigid tapping
MPG
Electronic tool probe which I’ve never used
Spindle coolant ring
It’s got the stronger coolant pump and better bearing supports
The crappy sensors have been swapped out for genuine Panasonic and Omron
It’s had a new X axis servo motor with a proper IP68 rated connector on it, to replace the OG molex connector wrapped in electrical tape it shipped with
Modified the lower door runner (ie all the ball bearings have burst out so it no longer gets jammed with chips. HUGE improvement!)

Also included would be a large amount of BT30 tooling (er chucks, set screw holders and 2x hydraulic milling chucks), a BT30 assembly pot, a tschorn 3D taster and an assortment of tnuts.

On top of that all the usual gear, servo’s on each axis, C3 ballscrews, footmaster castors with levelling feet, etc etc. I also have all the gear to add a proper wash down gun and a filter on the coolant, which has been sitting here awhile. Might put it all on today actually if I get chance.