. .

Threaded View

Previous Post Previous Post   Next Post Next Post
  1. 05-04-2019 #4
    ngwagwa's Avatar
    Lives in Preston, United Kingdom.
    ngwagwa
    Last Activity: 03-12-2020 Has been a member for 8-9 years. Has a total post count of 202. Received thanks 26 times, giving thanks to others 0 times.
    Hi, as well as the Porter cable being an open motor I was also worried about the run out. I am will be using some long reach ball neck tools so need to get down to a 3mm fillet.
    Last edited by ngwagwa; 05-04-2019 at 12:11 PM.
    Reply With Quote Reply With Quote
« Previous Thread | Next Thread »

Thread Information

Users Browsing this Thread

There are currently 1 users browsing this thread. (0 members and 1 guests)

Similar Threads

  1. Help required with mill conversion / upgrade.
    By swarf-boy in forum Milling Machines, Builds & Conversions
    Replies: 8
    Last Post: 06-12-2018, 12:33 PM
  2. Upgrade to x axis required. MG or HG rail
    By marbles in forum Rails, Guideways & Bearings
    Replies: 0
    Last Post: 10-12-2017, 01:51 PM
  3. Roland camm 2 pnc 2300 spindle upgrade help
    By iampete in forum Gantry/Router Machines & Building
    Replies: 0
    Last Post: 01-09-2014, 03:17 PM
  4. Kress Spindle upgrade to a 2kw
    By Metal pecker in forum Kress Milling Motors
    Replies: 4
    Last Post: 05-05-2014, 12:22 PM
  5. advice on upgrade to 5 axis control
    By alanb in forum General Electronics
    Replies: 17
    Last Post: 27-07-2012, 06:29 AM

Bookmarks

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  

Forum Rules