Luthier CNC

[bluesking]

Build started in earnest:

1 Y axis rough assembly


2 Y axis ballscrew


3 X axis assembly beginning


The gantry seems to move on its rails without binding - more by luck than by any concerted alignment effort. I'm not sure what freedom of movement I should be expecting though. It doesn't keep rolling after its been pushed.

Here is a vid of it being moved by hand. Can someone please check if this looks and sounds about normal?
https://streamable.com/u1pd2

Also, I have tried securing the ballscrew nut to the gantry. This seems to work OK, but at both of the extremes of travel, the resistance does go up quite a bit. I think I need to align the ballscrew more accurately to stop this happening. I'm finding this quite difficult - is there any advice you kind folks can offer?