Design Spark

[Doddy]

Eagle. If you can live with the limits of the free version - 80x100? double sided, limited schematic sheets

[Muzzer]

For quick and simple PCBs, I've used https://easyeda.com/ from JLCPCB which integrates with their sister company LCSC's online component shop. If you use the associated library, you can then order the resulting PCBs and parts in one order so that the whole project arrives together. The free version of the layout tool is fairly comprehensive and includes an autorouter. The main difference from the full cream version is that you can't create your own parts library.

I discovered that the downside of ordering PCBs and compts together is that the combined value attracts those silly tax / duty / admin charges on the way into the UK. That sort of wiped out much of the saving, so next time I will order them separately. If you order just the PCBs, they cost $2 for 5 (plus P&P) for 2-sided boards up to 100mm x 100mm on a 24h turnaround. You can track their progress through the factory.

[cropwell]

I have downloaded and installed Altium Circuit Maker, and from what I have seen and tried, it looks promising. The next step is to make a simple project to test if the Gerber files are OK.

[m_c]

I use DipTrace.
If you're using it for hobby, and you do need a higher pin/layer limit, they'll give you an upgrade for free. IIRC the free option has a 500pin limit, which I've only ever went above once.

[Voicecoil]

I use FreePCB. I was initially attracted by the free bit, but rapidly realised it was a nice not over-complicated intuitive application - obviously written by a real engineer, not a disjointed team of code heads who've never had to lay out a board.

[cropwell]

Well, Altium Circuit Maker got ditched. It was OK for doing schematics, which I have done and printed. For this one-off project, I am going to build it on protoboard. This, in a way, is fecking annoying. as I wanted to try isolation milling again. I have CopperCam to do the conversion of Gerber to Gcode.

So - what did I find wrong with Altium CM----

1. Lack of Help documentation.
2. Cloud based storage only.
3. Rigid development pathway. (1 PCB per project - I needed 1 PCB per schematic)
4. Alien vocabulary. I do not speak Nerdish.
5. Forking didn't work! (if you use Altium CM you may realise that is a pathetic joke!)
6. Tutorial videos were done by a super-annoying young American with a high voice.

I will re-address the issue of routing (pronounced rooting not rowting) tracks of a circuit to design a PCB which can then be isolation routed (this one you can pronounce rowting), when my frustration levels reduce to the point that my forehead is not in danger of demolishing a wall.

Thanks everyone, for the input, I will get back to evaluating these suggestions soon.

Cheers,

Rob-T

[AndyGuid]

. . . . .
I will re-address the issue of routing (pronounced rooting not rowting) tracks of a circuit to design a PCB which can then be isolation routed (this one you can pronounce rowting), when my frustration levels reduce to the point that my forehead is not in danger of demolishing a wall.
. . . . . .

One problem with British pronunciation down under is that routing (pronounced rooting not rowting) refers to act of copulation, as far as I have been able to ascertain between the giggles of others when I slip up!

[Doddy]

Forking didn't work!

A reasonable summary :-)