Thread: Motion controllers
Threaded View
-
10-05-2019 #1
Hi
I'm building a Cnc router with dual gantry stepper motors, I can change design to belt drive to get gantry correction if needed but would prefer dual steppers for simplicity.
Can you recommend which controller to use, or direct me to a good link to help me choose.
Is there a common controller used by most?
I was planning on using Mach 3 as there is a big support group and lots of set up videos.
It don't have to be Mach 3 so any advise would be great.
I've read a few posts but as its all new to me I don't really know what features I'm looking for.
The only thing that is important to me is the support, so one that is well used in the community and I can get the help where needed.
Any information would be appreciated .
Regards Paul
Thread Information
Users Browsing this Thread
There are currently 1 users browsing this thread. (0 members and 1 guests)
Similar Threads
-
FOR SALE: PoKeys CNC Controllers
By MrBurns in forum Items For SaleReplies: 0Last Post: 08-05-2017, 03:28 PM -
Any experience of Novusun Ethernet motion controllers?
By Doddy in forum Control Hardware & SystemsReplies: 0Last Post: 28-12-2016, 10:50 AM -
Comparing motion controllers...
By JW1977 in forum Control Hardware & SystemsReplies: 34Last Post: 17-02-2016, 02:36 PM -
Wiring Steppers to controllers
By liamo1991 in forum Motor Drivers & ControllersReplies: 1Last Post: 05-09-2013, 01:58 AM -
PCI Motion Controllers
By IanS1 in forum Motor Drivers & ControllersReplies: 0Last Post: 16-05-2013, 12:13 AM
Bookmarks