Motion controllers

[Kitwn]

Just crunched the numbers and the basic Acorn plus overseas delivery plus the essential software upgrade comes to $710AUD so I think I'm sticking with LinuxCNC for now!

Good luck with the build.

Kit

[Crunch]

Hi
Any advice on
Uc300eth Ub1 ?
AXBB-E ?
Thank you for your replies.

[Ger21]

I have both, and both have similar features.
An AXBB-E with a UCSB breakout board on the 3rd port gives you about the same I/O as the UC300-UB1, for about $100 less.

If you need more I/O, you'd want the UB1 + UD1 daughterboard.

The UB1 has a few more features, like 3 relays, and differential step/direction. And it only requires a single 214V supply, where the AXBB needs both a 24V and a 5V power supply.
An 8 channel 24V relay board is only about $15 from China.