Threaded View
-
27-05-2019 #4
Last Activity: 05-05-2024
Only if the driver gives Mach3 direct access to pin status control, it is not driven as a Parallel Port, doing so does not give motion control.
Originally Posted by myles.merry
You think that's too expensive? You're not a Model Engineer are you? :D
Reply With QuoteThread Information
Users Browsing this Thread
There are currently 1 users browsing this thread. (0 members and 1 guests)
Similar Threads
-
running mach 3 with a usb to parallel adapter
By Kendrick57 in forum Artsoft Mach (3 & 4)Replies: 40Last Post: 06-01-2020, 04:49 PM -
windows 10 64bit and breakout board
By terry1956 in forum Computer SoftwareReplies: 2Last Post: 23-01-2017, 02:14 PM -
CSMIO/IP-M vs Ethernet SmoothStepper (Begone foul parallel port!)
By Greeny in forum Control Hardware & SystemsReplies: 20Last Post: 14-11-2013, 11:59 PM -
problems with mach or windows
By johngoodrich in forum Computer SoftwareReplies: 2Last Post: 02-03-2012, 07:23 PM -
Mach 2 / 3 - Windows 2000/XP
By teetat in forum Artsoft Mach (3 & 4)Replies: 3Last Post: 10-07-2009, 02:47 PM
Bookmarks