Generic Chinese VFD, XSY-AT1 Programming Parameters/Settings

[Spyke]

Hello,

During my search on the internet about the settings of the XSY-AT1 I came across this forum.

I have the 1.5 KW version and a 1.1 KW motor with 2780 revolutions. Without load the motor runs, but when I hold the shaft it has no power and just stutters, the VFD then shuts down with Error 1.
It seems like the VFD is overloaded with the starting current.

I will upload a video on Youtube and post the link here.

I would be happy if you could give me tips on the settings.

Best thanks
Many greetings
Marc

[routercnc]

I am using the XSY-AT1 invertor in my drill press upgrade, video series starts here:



I talk through all the parameters I used in episode 2. Skip to 17:17 if you just want the parameters part:



Below is a pdf of my version of the parameter sheet as the one supplied is quite hard to follow. I colour coded it according to whether I thought the parameter was required for setting up the motor, preferences, input devices, advance users and not documented.
This may be of some help, but use at your own risk:
XSY-AT1_parameters.zip


Error code 1 = module protection
Error code 2 = under voltage protection
Error code 3 = over voltage protection
Error code 4 = driving circuit failure
Error code 5 = input at startup when electrified
Error code 6 = over current protection
Error code 7 = overtime
Error code 8 = excessive temperature for radiator
Error code 9 = external fault