. .

Thread: Quick question

Hybrid View

Previous Post Previous Post   Next Post Next Post
  1. #1
    Not all phone chargers are regulated that well and may be close enough to charge a battery but

    not good enough to power my expensive uc300eth if I had one

    Cheap chinese chargers can be very dangerous with poor insulation between the mains supply and the 5V DC output

    https://youtu.be/bNoGCdX1IdQ

    John

  2. #2
    Have a look at the 5V DIN rail mounted supplies. The Meanwell branded ones are around £12 shipped (to UK). This is assuming you will have a control box with everything inside as the mains terminals are potentially accessible.
    Building a CNC machine to make a better one since 2010 . . .
    MK1 (1st photo), MK2, MK3, MK4

  3. #3
    I agree with routercnc, i use them too. Much better option than phone psu

Thread Information

Users Browsing this Thread

There are currently 2 users browsing this thread. (0 members and 2 guests)

Similar Threads

  1. About to take the plunge - quick power question 3020 CNC
    By Sherpa in forum Chinese Machines
    Replies: 5
    Last Post: 23-09-2016, 10:41 PM
  2. Just starting out - quick question
    By glynster in forum Gantry/Router Machines & Building
    Replies: 3
    Last Post: 06-02-2015, 06:20 PM
  3. quick question about lead screw
    By japcarmaniac in forum Gantry/Router Machines & Building
    Replies: 2
    Last Post: 09-02-2013, 11:25 PM
  4. Quick cable question
    By PWD in forum General Electronics
    Replies: 18
    Last Post: 11-12-2012, 09:25 PM
  5. Quick question
    By m.marino in forum General Discussion
    Replies: 2
    Last Post: 18-02-2011, 04:30 PM

Bookmarks

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •