eMachineShop Upgrade

[Bladevane]

Gary, You should have the link on Dropbox for versions 1.932 and 1.935. Regards.

[amarillis]

Hi there. I do not have dropbox installed. Is there any way to have the 1.932 version of the SW?
Thanks in advance
Regards

[Bladevane]

Matt, As far as I know when you have created an account in Dropbox using the same email address as on this forum ([email protected]) you should receive a link to Dropbox to allow the download of the files. It has worked for the other 40 users so I can't see why it should be different for you. Regards.

[sandrahof]

I found it as well, it's working with no problems. The previous version was very troublesome though, and I lost a lot of files and documents which were very important. The good thing is that I managed to recover them back with the help of DATA RECOVERY SERVICES, and now I am being more careful of where I am saving my important files. It's always good to have an additional copy on an external hard disk, now I've learned my lesson and don't wanna repeat the same mistake twice.

[amarillis]

So, I created my dropbox account: [email protected]
Can you please add me to the list?
Thank you
Regards
Amarillis

[Bladevane]

Hi Amarillis, All done. You should have access to versions 1.932 and 1.935. Regards.

[Bladevane]

I'm no expert but I think that versions later than 1.935 save the file in a format that 1.932 and 1.935 can not read. I create all my drawings in 1.932. You might have to do the same but
I am sure someone with better knowledge will be along soon to give you better advice. Regards.

[amarillis]

Well, thank you very much for your replay!
I really appreciate it!
And, by the way, maybe your are not an EXPERT but your knowledge is way deeper than mine...
So, with that said, your replay is a perfect recap of all the operations we should do to make a DXF or STL type of files using version 1.932/35...
Thank you again, I will give it a try in the next days...
Regards
Amarillis

[Bladevane]

Malcolm, I feel your pain. I can try to do what you are after. I will send you my email address by PM so you can send the drawing over. Regards.

[Malcolm Vermeulen]

HI

thanks for the reply... please any assistance will be greatly appreciated.

my email

shopsbt at outlook dot com

thanmks

Malcolm