. .

Threaded View

Previous Post Previous Post   Next Post Next Post
  1. 01-08-2019 #8
    magicniner's Avatar
    Lives in Rotherham, United Kingdom.
    magicniner
    Last Activity: 05-05-2024 Forum Superstar, has done so much to help others, they deserve a medal. Has been a member for 9-10 years. Has a total post count of 2,021. Received thanks 230 times, giving thanks to others 42 times.
    If the VFD is not of exceptionally poor design you will be able to hard wire an E-Stop switch directly to the VFD data inputs and configure the function in parameters if required, when activated this will over ride any other signal trying to power on the spindle until the E-Stop switch is reset.
    You think that's too expensive? You're not a Model Engineer are you? :D
    Reply With Quote Reply With Quote

  2. The Following User Says Thank You to magicniner For This Useful Post:

« Previous Thread | Next Thread »

Thread Information

Users Browsing this Thread

There are currently 1 users browsing this thread. (0 members and 1 guests)

Similar Threads

  1. Bob for spindle control
    By Duffman in forum General Discussion
    Replies: 8
    Last Post: 29-12-2016, 02:14 PM
  2. [HELP] 6 Axis B.O.B with spindle control
    By birchy in forum General Discussion
    Replies: 7
    Last Post: 02-10-2014, 12:15 AM
  3. PCPPS B.O.B. - OK for spindle control?
    By birchy in forum Spindles & Drive Motors
    Replies: 4
    Last Post: 09-09-2013, 12:50 AM
  4. Spindle on/off under CNC software control - safety worries!
    By HankMcSpank in forum Machine Control Software
    Replies: 13
    Last Post: 12-02-2013, 03:47 AM
  5. Help with spindle control
    By wizzy in forum Spindles & Drive Motors
    Replies: 4
    Last Post: 12-02-2011, 12:51 AM

Bookmarks

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  

Forum Rules