Hybrid View
-
01-08-2019 #1
Hi Doddy
not sure we are looking at the same board
the picture of the 5LPT-UC300 Motherboard
I am looking at has seven 14 pin IC's
possibly non inverting hex buffers ? (74HC365E ?)
[ with 6 inputs , 6 outputs & 2 supply pins ]
or 7414 inverting hex buffer found on some breakout boards
octal buffers like the 74245 have 20 pins -
8 inputs, 8 outputs, 2 supply (Vcc & Gnd) , 1 enable & 1 bi direction data control
John
PS
Just downloaded the UC300ETH manual (again) and see
2 ports have 12 outputs (like a PC printer port ) and the other
3 ports have only have 4 outputs
giving you a total of 36 digital outputs
so 7 hex buffers gives you 42 digital buffers to be used to buffer the micro controllerLast edited by john swift; 01-08-2019 at 01:56 PM. Reason: add PS
Thread Information
Users Browsing this Thread
There are currently 1 users browsing this thread. (0 members and 1 guests)
Similar Threads
-
Overheating stepper motors
By Skysurfer in forum Stepper & Servo MotorsReplies: 3Last Post: 01-08-2019, 11:43 AM -
microstepper overheating
By Matthew in forum Motor Drivers & ControllersReplies: 1Last Post: 20-05-2015, 03:36 PM -
Overheating stepper motors
By Skysurfer in forum Motor Drivers & ControllersReplies: 2Last Post: 06-05-2014, 12:40 PM -
spindle bearings overheating
By Andrew Wilding in forum Spindles & Drive MotorsReplies: 9Last Post: 15-05-2011, 01:21 PM
Bookmarks