. .

Threaded View

Previous Post Previous Post   Next Post Next Post
  1. 12-08-2019 #11
    CharlieRam's Avatar
    Lives in Derby, United Kingdom.
    CharlieRam
    Last Activity: 19-04-2024 Has been a member for 9-10 years. Has a total post count of 234. Received thanks 20 times, giving thanks to others 34 times.
    In the ucnc software I can configure which outputs to use for the charge pump so I was planning on setting it to the output 17 in the bob which is for the relay or forward reverse control but it isn't switching the relay which is why I think I need to power it from the ish rather than the on-board 5v connectors. I've included the pdf for the bob

    I appreciate the help John
    Edit.
    I should probably add that the bob is connected to port 3 of the AXBB and not to the pc parallel port.
    https://cloud.tapatalk.com/s/5d514e97...%20%281%29.pdf

    Sent from my SM-G920F using Tapatalk
    Last edited by CharlieRam; 12-08-2019 at 12:51 PM.
    Reply With Quote Reply With Quote
« Previous Thread | Next Thread »

Thread Information

Users Browsing this Thread

There are currently 1 users browsing this thread. (0 members and 1 guests)

Similar Threads

  1. Advice on a charge controller please :)
    By blackburn mark in forum General Electronics
    Replies: 23
    Last Post: 04-05-2020, 07:28 PM
  2. CNCDrive AXBB super deal?
    By driftspin in forum CNCdrive (UC100, UC300ETH)
    Replies: 18
    Last Post: 16-03-2019, 10:10 PM
  3. Not sure where the fault lays
    By terry1956 in forum Vectric
    Replies: 5
    Last Post: 20-02-2019, 11:28 AM
  4. fault testing
    By Palletlad in forum General Computing
    Replies: 2
    Last Post: 09-02-2018, 05:51 PM
  5. Jun-Air Compressor Fault
    By jamesgates1000 in forum General Discussion
    Replies: 5
    Last Post: 02-12-2017, 07:59 PM

Bookmarks

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  

Forum Rules