. .

Threaded View

Previous Post Previous Post   Next Post Next Post
  1. 13-08-2019 #11
    CharlieRam's Avatar
    Lives in Derby, United Kingdom.
    CharlieRam
    Last Activity: 19-04-2024 Has been a member for 9-10 years. Has a total post count of 234. Received thanks 20 times, giving thanks to others 34 times.
    So I got a response that it could be the input transistor. I have asked whether it is covered under warranty but haven't had a response yet however I decided to check the values myself and the resistors seen in the pic below should be....
    30B=2k
    221=220ohm
    01C=10k
    All the values are correct other than the one circled which gives more like 1k value so in your opinion is it blown or do you think there is a path from elsewhere?

    Edit
    How easy is it to replace a faulty smd and what would be an acceptable cost at an electronica shop? I'm just wondering if the cost will be cheaper than shipping back to CNCDrive.



    Sent from my SM-G920F using Tapatalk
    Last edited by CharlieRam; 13-08-2019 at 03:53 PM. Reason: Additional question
    Reply With Quote Reply With Quote
« Previous Thread | Next Thread »

Thread Information

Users Browsing this Thread

There are currently 2 users browsing this thread. (0 members and 2 guests)

Similar Threads

  1. Advice on a charge controller please :)
    By blackburn mark in forum General Electronics
    Replies: 23
    Last Post: 04-05-2020, 07:28 PM
  2. CNCDrive AXBB super deal?
    By driftspin in forum CNCdrive (UC100, UC300ETH)
    Replies: 18
    Last Post: 16-03-2019, 10:10 PM
  3. Not sure where the fault lays
    By terry1956 in forum Vectric
    Replies: 5
    Last Post: 20-02-2019, 11:28 AM
  4. fault testing
    By Palletlad in forum General Computing
    Replies: 2
    Last Post: 09-02-2018, 05:51 PM
  5. Jun-Air Compressor Fault
    By jamesgates1000 in forum General Discussion
    Replies: 5
    Last Post: 02-12-2017, 07:59 PM

Bookmarks

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  

Forum Rules