. .

Hybrid View

Previous Post Previous Post   Next Post Next Post
  1. #1
    Quote Originally Posted by Ger21 View Post
    Sorry old friend, didn't see the email.
    Had a bad back earlier this year that put me out of commission for about 6 weeks. And projects at the new house have kept me incredibly busy.
    The screenset is at the top of my todo list, as soon as I can find the time. Trust me, I want it done as much as everyone else.
    Sorry to hear that Gerry, I know all about Bad backs I've had one on and off for over 30yrs, one wrong sneeze can make putting my underpants on a massive chore...

    Let me know when you get it done or if need any help testing etc.
    -use common sense, if you lack it, there is no software to help that.

    Email: [email protected]

    Web site: www.jazzcnc.co.uk

  2. #2
    Quote Originally Posted by JAZZCNC View Post
    Sorry to hear that Gerry, I know all about Bad backs I've had one on and off for over 30yrs, one wrong sneeze can make putting my underpants on a massive chore...

    Let me know when you get it done or if need any help testing etc.
    I've just had 2 spinal nerve block injections, so you're not alone guys

    I also need to figure out my estop circuit and wire up all my inputs next. I'll be looking through all the advice that's been given.
    No £5 bob's this time, hope to do this one properly.
    (Even though my box has turned out to be a little small ) Balls!.

Thread Information

Users Browsing this Thread

There are currently 2 users browsing this thread. (0 members and 2 guests)

Similar Threads

  1. Advice on a charge controller please :)
    By blackburn mark in forum General Electronics
    Replies: 23
    Last Post: 04-05-2020, 07:28 PM
  2. CNCDrive AXBB super deal?
    By driftspin in forum CNCdrive (UC100, UC300ETH)
    Replies: 18
    Last Post: 16-03-2019, 10:10 PM
  3. Not sure where the fault lays
    By terry1956 in forum Vectric
    Replies: 5
    Last Post: 20-02-2019, 11:28 AM
  4. fault testing
    By Palletlad in forum General Computing
    Replies: 2
    Last Post: 09-02-2018, 05:51 PM
  5. Jun-Air Compressor Fault
    By jamesgates1000 in forum General Discussion
    Replies: 5
    Last Post: 02-12-2017, 07:59 PM

Bookmarks

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •