Hey guys,

I have been following this thread with great interest. Really great work.

I really like they way the camera + software is used for this purpose. It smells like a commercial oppertunity in my opinion.

Anyway, Since i bought a new house i am about to move my cnc machine in about a month or two.

I think i could use a laser level device for some of the needed remodelling work so that one could pass investment committee.

I would like to use this technique for a check on my machine after transport.

Actually.. it would be the first time and method i could set up for a half decent check on my machine.



So i would like to buy a new laser device with this in mind.

I only have an 8 mm umbilical type usb HD cam atm. So a really small chip.. i guess not usable for this pupose.

Maybe it could be with the indirect method putting the camera behind the screen.
Is that idea abandoned?

Are you guys using 640x480 on purpose?
Do low res low cost chips have the wanted size / resolution / pixels per mm.
So no need/advantage for throwing a few extra pecunia?

So does a laser level loc in position after setup?

Or do you have to trust the deviation is constant / repeatable.

Greetings Bert


Verstuurd vanaf mijn SM-A320FL met Tapatalk