DIY Laser levelling using webcam and laser level

[JAZZCNC]

Jazz will need something far more accurate than the cheap rubbish your typical builder will likely have.

I agree Moray, my experience of builders laser level hasn't left me blown away either.
If this build happens then I'll look deeper into laser leveling and probably go hire the equipment I need or get one of the guys I now in when setting up the rails.
To be honest the precision doesn't need to be super high because one gantry will be used with Circular saw attached so no great accuracy required at all. The other will be mostly 2D profiling and edge molding using special profile edge tooling and polishing heads. Only making Kitchen countertops so flatness isn't to precision levels and most of the finishing is done by hand. At the moment all of the cutting, shaping, and polishing are done by hand so will be a massive improvement. They just need to save up some penny's or speak nicely to bank manager...Lol