Quote Originally Posted by John McNamara View Post
Hi Imclaren

Your timing is good Leolfs and I have been discussing getting the project underway, We have already purchased the ball screws and linear rails. the initial design for the laser cut components is complete.

The need is to connect the machine to devmonkeys software he that he outputs to the screen, fairly simple I guess once we get a handle on the code he posted.

Any contribution will be appreciated.

I do hope devmonkey is well, if anyone knows him personally send him my regards.

Regards
John

What sort of output would you like?
I am guessing that the error signal that is shown as a bar on the right is what you are after?
Are you running this on specific hardware that has a suitable hardware output or would you like a serial data stream from a comm port with an error value?

What sort of input does your motor controller want? step / dir or error signal?