. .

Threaded View

Previous Post Previous Post   Next Post Next Post
  1. 15-09-2019 #20
    Doddy's Avatar
    Lives in Preston, United Kingdom.
    Doddy
    Last Activity: 4 Days Ago Has been a member for 9-10 years. Has a total post count of 1,364. Received thanks 188 times, giving thanks to others 66 times. Referred 1 members to the community.
    If you believe it's the spindle (and this is not unlikely), then look at the shielding on the cable to to machine - ensure that it's grounded both ends and ensure that controller and machine share a low impedance path to earth. Share a common earth at the controller for the shielding on all inputs to the controller and/or use differential inputs with/without shielding. Get some ferrites on the supply to the VFD, and to the gamepad.
    Last edited by Doddy; 15-09-2019 at 02:23 PM.
    Reply With Quote Reply With Quote
« Previous Thread | Next Thread »

Thread Information

Users Browsing this Thread

There are currently 1 users browsing this thread. (0 members and 1 guests)

Similar Threads

  1. AXBB charge pump fault
    By CharlieRam in forum CNCdrive (UC100, UC300ETH)
    Replies: 78
    Last Post: 18-07-2021, 08:31 PM
  2. CNCDrive AXBB super deal?
    By driftspin in forum CNCdrive (UC100, UC300ETH)
    Replies: 18
    Last Post: 16-03-2019, 10:10 PM
  3. got 2 outputs from controller, need to connect 3 leds to them, any solution?
    By Noplace in forum CS-Lab (CSMIO)
    Replies: 5
    Last Post: 04-02-2016, 08:51 PM
  4. Advice needed for controller box layout
    By Bustercnc in forum General Electronics
    Replies: 23
    Last Post: 18-01-2016, 01:16 PM
  5. Help needed Dahlgren System 4824 And a DSC controller, what software will run it???
    By fraserguitars in forum Machine Discussion
    Replies: 0
    Last Post: 13-12-2015, 08:22 PM

Bookmarks

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  

Forum Rules