Thread: switches settings in mach3
Threaded View
-
14-09-2019 #1
Hi all,
I installed switches to my 6040 today (parallel running 2xX 2xY 2xZ) and cannot get mach3 to register them.
I am using a UC400eth controller so no printer cable connection used and i have tested the physical side which all checks out correctly done. i set them as pin 11,12 and 13 for xyz home. any suggestions on what I'm missing?
Almost forgot i set them up as open circuit.
Kind RegardsLast edited by Palletlad; 14-09-2019 at 10:47 PM.
Thread Information
Users Browsing this Thread
There are currently 1 users browsing this thread. (0 members and 1 guests)
Similar Threads
-
Help please. Dip switches and mach 3 settings
By Radu_Andrei in forum Motor Drivers & ControllersReplies: 261Last Post: 16-11-2019, 02:48 PM -
G540, homing switches and mach3
By marbles in forum Artsoft Mach (3 & 4)Replies: 11Last Post: 02-06-2018, 02:55 PM -
Mach3 Setting up home and limit switches
By CrazeUK in forum Gantry/Router Machines & BuildingReplies: 3Last Post: 03-02-2017, 01:18 PM -
Help withController dip switch settings and Mach3 motor tuning
By liamo1991 in forum Motor Drivers & ControllersReplies: 2Last Post: 15-11-2013, 02:22 AM -
Limit switches and Mach3
By cropwell in forum Artsoft Mach (3 & 4)Replies: 1Last Post: 06-03-2013, 10:51 AM
Bookmarks