New Spindle drive Boxford V190 VMC

[mosoeng]

There is no reversing circuit, thats why its not working, 2 relays have no wires going into them.
As the LENZE has no stop/ccw or stop/cw input do I just rout 2 wires from the motor through the relays?
if so can someone do me a sketch of the wiring pls.

[magicniner]

There is no reversing circuit, thats why its not working, 2 relays have no wires going into them.
As the LENZE has no stop/ccw or stop/cw input do I just rout 2 wires from the motor through the relays?
if so can someone do me a sketch of the wiring pls.

The manual states that the motor must be stopped before reversing direction and that reversing direction should be achieved by reversing the polarity of the stator windings, that shouldn't be too complicated but you will need to identify what you have to work with, i.e. what are the relays, I assume they are at least DPDT? what's the relay field coil voltage? Plus what output from your controller you expect to trigger the relays with, a 5v logic output from a BOB is not going to run a 24v or relay.

If you plan to reverse under programmed control you will need to consider how you are going to ensure that the motor stops before reversing, that might be as simple as editing your post processor to add a suitable pause before any spindle direction change