. .

Threaded View

Previous Post Previous Post   Next Post Next Post
  1. 19-09-2019 #6
    JAZZCNC's Avatar
    Lives in wakefield, United Kingdom.
    JAZZCNC
    Last Activity: 19-01-2024 Forum Superstar, has done so much to help others, they deserve a medal. Has been a member for 9-10 years. Has a total post count of 8,446. Received thanks 1,445 times, giving thanks to others 109 times.
    If it's only going in one direction with either keypress on just one axis then it's usually 99% of the time a Bad Connection on the Direction Pin. It's certainly the first place to look.
    If it's doing this on more than one axis then I'd look at the Keyboard first and just replace it.

    After this, it starts getting a bit more into the unknown and could be anything from bad connection/broken wire to controller or drive on it's way out.?? . . . . More info would be needed to advise properly.
    Last edited by JAZZCNC; 19-09-2019 at 06:36 PM.
    Reply With Quote Reply With Quote
« Previous Thread | Next Thread »

Thread Information

Users Browsing this Thread

There are currently 1 users browsing this thread. (0 members and 1 guests)

Similar Threads

  1. Sheet support for a plasma machine?
    By Davek0974 in forum Plasma Table Machines
    Replies: 11
    Last Post: 10-02-2014, 08:44 PM
  2. App calculator feed and speed windows phone
    By hoezap in forum Computer Software
    Replies: 2
    Last Post: 14-02-2013, 11:44 PM
  3. OneCNC - The Mobile Phone
    By Gilly in forum OneCNC
    Replies: 9
    Last Post: 18-05-2009, 07:56 PM
  4. plasma build log - sort of
    By mike techserv in forum DIY Plasma Build Logs
    Replies: 0
    Last Post: 23-04-2009, 10:15 AM

Bookmarks

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  

Forum Rules