Hi Guys

thank you all, I'm going for the din rail type of holders (fuse)

so for my motors....
http://www.axiscnc.com/pdfdocs/sy85sth1184208a.pdf

setting these up in unipolar (4.2) i have the 82K +/- 5% 1/4W Resistors which i think is just right for the drivers with the motor settings ?

so am i right in thinking a 12amp fuse! i cant seem to find the trip style of fuse so should i still go with the slow blow 12amp glass fuse ?

my driver specs are here http://www.geckodrive.com/upload/G203V-REV-7-MANUAL.pdf

says something regarding 10amp short circuit trip protection

so would a 10amp fuse be good before it gets to the drive ?

oh i wish i was electrical minded!