Quote Originally Posted by kingfisher View Post
thanks guys


right yes i will keep to these settings, Bipolar Parallel...4.5A with the 82k resistors! if i need to change setup at a later date then so be! (funds are running low)
all the fuse gear is on its way also my steel cabinet to house all the parts.
anyone on the wiring for the motors with the setting above (Bipolar Parallel)

oh...please a link to some wire for the controller set up (in the box,power,drivers,breakout board) i have some shielded wire for the motors, I'm sure you guys know the best place to buy ?

once again i cant thank you all enough and so glad i posted here!
hookup wire for linking breakout to drivers and other low voltage stuff, use standard 7/0.2 equipment wire available from Maplins amongst other places. A good colour scheme helps with fault finding...

For wiring power supply to drivers use the same wire as for the driver to motors. you will need a 4-way 10A connector block to transition from the 4-core wire to the motor wires.