. .

Thread: Time to share

Threaded View

Previous Post Previous Post   Next Post Next Post
  1. 12-10-2019 #8
    Sasquatch's Avatar
    Lives in Basildon, United Kingdom.
    Sasquatch
    Last Activity: 08-11-2019 Has been a member for 5-6 years. Has a total post count of 26.
    Thanks for casting advice, I'll stick to scraping.
    I'm sure casting works sometimes, but, I prefer more predictable results.

    Meniscus wasn't big problem, IN2 epoxy from easycomposites is setting in very irregular way. It looked like skin was forming in random areas and pulling surface up between meniscus on the walls. It was up and down 0.1mm. To be clear : I mixed it well ->electric drill with spiral paint mixer->5 minute vacuum degas->pour. I didnt go with west epoxy as i figured that 20 minutes pot life won't give me enough time for degas.
    Last edited by Sasquatch; 12-10-2019 at 11:23 PM.
    Reply With Quote Reply With Quote
« Previous Thread | Next Thread »

Thread Information

Users Browsing this Thread

There are currently 1 users browsing this thread. (0 members and 1 guests)

Similar Threads

  1. NEW MEMBER: Long time lurker, first time poster.
    By MatB in forum New Member Introductions
    Replies: 1
    Last Post: 18-02-2019, 05:49 PM
  2. Share some PCB design sites which may be helpful
    By Vicos in forum General Electronics
    Replies: 0
    Last Post: 22-08-2016, 08:10 AM
  3. NEW MEMBER: Hello - Keen To Share and Learn
    By dodo in forum New Member Introductions
    Replies: 5
    Last Post: 20-02-2013, 12:09 AM

Bookmarks

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  

Forum Rules