mach3 help

[D-man]

thanks guys,

My motor wiring is parallel and are wired as follows...
A+ = Yellow with White stripe & red
A- = yellow & Red with White stripe
B+ = Green with White stripe & Black
B- = green & black with white stripe.

I have just used normal wire for now to connect the drivers to the uniport but i read somwhere that would be fine for a test but replace them when they get installed.

Lateatnight - your switches i will try mine the same way but which way have you ran them? e.g pin 1-2-3-4-5-6-7-8

[lateAtNight]

Yep 1 to 8.

Can't help with the wiring... Mine have different colours.