mach3 help

[HiltonSteve]

I have taken a look at the program for the step clamp and yes there is a lot of Z movement, it roughs the clamp by plunge roughing which means it basically drills holes all over it to remove the bulk of the material. Not my favourite way of roughing and certainly would not do it like that myself!

Checked my settings and attached a jpeg showing what mine are set to, your pin outputs are completely different to mine to the point were I can't see how it is working at all! Are you sure you are using a uniport board? can you post a photo of it. This could be down to your wiring though, I would just double check your connections again.