Threaded View
-
19-12-2019 #19
Last Activity: 28-05-2023
Hi
I presume you are in 32bit mode, it may have been mentioned before. If you are using an onboard LPT socket then you will need to go into onto the BIOS to set the mode to EPP/ECP. If you are using a PCI card then you must have a 5v one, the 3.3v ones will not work reliably, if at all.
There is no mode setting needed on a PCI ports card.
Rob-T
Reply With QuoteThread Information
Users Browsing this Thread
There are currently 1 users browsing this thread. (0 members and 1 guests)
Similar Threads
-
CNC problems
By martythunder in forum General DiscussionReplies: 1Last Post: 15-02-2017, 08:10 PM -
Mach3 Problems problems problems.
By ECCO in forum Artsoft Mach (3 & 4)Replies: 18Last Post: 09-07-2016, 10:07 AM -
tree problems!
By kingcreaky in forum Woodwork DiscussionReplies: 8Last Post: 02-06-2014, 12:35 PM -
problems since update
By motoxy in forum General DiscussionReplies: 6Last Post: 02-11-2012, 06:14 PM -
NEW MEMBER: MDF Problems
By MrWiz73 in forum New Member IntroductionsReplies: 4Last Post: 31-12-2011, 12:39 AM
Bookmarks