Thread: new here and totally new to cnc
Threaded View
-
18-10-2019 #1
Ask you can tell from the title im a new member and new to the hobby.
(and a new way to keep out of my partners hair)
iv been looking all over the net for ideas on building a cnc router, there is a lot to read through but im guessing some or most of you all ready know that,
i think iv found a build im going to make a mess of by building it my self, but as with every build ill be putting some of my own changes in.
one thing im not quite clued up on is the controller for the cnc, iv seen there is a mass variety out there, ill hold my hands up and admit im not going to be spending to much money on my first build, So here comes the word china.
iv seen you can get all in one controller driver setup and the one that im interested im at the moment is this one
or is it better to use separate drivers, not forgetting the purse strings attached to my partners fingers
its quite a cheap option, ill be trying not to fry nema 23 motors on it (3 axis), im using the moving gantry method, construction will consist of steel or aluminium box tubing (just alittle worried about weight issues - what have other people used for construction and what have the found works best under budget)
using T8 lead screws to drive the x, y, and z axis
well thanks for getting this far with me aas im shore these question have been asked a few 100 times,
bu any information people are willing to part with would be fantastic
Thread Information
Users Browsing this Thread
There are currently 1 users browsing this thread. (0 members and 1 guests)
Similar Threads
-
NEW MEMBER: Totally Green CNC Oldie Needs A Start Point
By NeoMorph in forum New Member IntroductionsReplies: 2Last Post: 04-07-2017, 09:53 AM -
NEW MEMBER: Totally new from Leeds / Stevenage / Manchester
By CrazeUK in forum New Member IntroductionsReplies: 0Last Post: 28-01-2017, 01:18 AM -
NEW MEMBER: Totally new.
By Jan in forum New Member IntroductionsReplies: 6Last Post: 03-12-2015, 10:54 AM -
Totally Lost
By AirbusMan in forum Machine DiscussionReplies: 3Last Post: 27-09-2014, 03:21 PM
Bookmarks