Joe's 1000x600x200 steel and aluminium router started

[devmonkey]

Was still waiting for the pulleys this morning so decided to align the Z axis assembly and fit the ballscrew. I needed a 0.25mm/10thou shim between the ballnut holder and Z-plate, but it was extremely difficult to get the shim into place as the holder is buried between the rails inside the assembly. A bit of lateral thinking and I used some plastic lamination film cut from a normal A4 laminating pouch.

This stuff has the advantage of a) being quite hard after lamination,b) having a heat activated adhesive. So using an old iron I laminated 4 layers of the stuff onto the back of the ballnut holder, this formed the perfect shim. I trimmed it with a scalpel and cut the bolt holes. Worked really well. Z axis is now complete apart from lubrication points. These are a pain with the nipples supplied with the hiwin carriages and the ballscrew so will need some thinking.



Just as I finished the Z the delivery guy turned up with my belts and pulleys, so I spent a rather boring couple of hours, boring, reaming, cross drilling and tapping 8 steel pulleys. All done now. I only installed one M5 grub screw per pulley, each shaft will have a flat on it, hopefully this will be sufficient. I could do with some longer grub screws, or maybe just use an M5 bolt given the low RPMs.