PC case control box

[Lee Roberts]

Yo,

yea i was going to post up a build log with all the pics and so on, yea i liked the idea of using the drive bays as well, the tower is sat in front of me now, the plan was to extened the driver L.E.D's onto the front beisel? with fuses and so on.

I was also going to swap the pooh red and green L.E.D's fitted to the case and replace them with clear bule ones, but no never got that far.

Yea i'v got an older AMD based PC inside the case with all the other stuff, didnt see/notice any problems.

The cable brading i got from the USA on 300m drums, dont know how much is left now as i used to sell it on ebay. I know i'v got lots of the smaller size left, they use it for ICE installs and stuff like that on cars.

Steve i'v got a few big sheets of Ali, think its somthing like 1.5mm thick, its just sitting here if you can use that for this project ? I'v got some 200x200mm cut ready to go, shouldnt cost much to post it to you ?

Thanks,
Lee

[HiltonSteve]

I have got a load of that 'black cable tidy stuff' as well, got a couple if sizes which should do you, let me know if you need some of that as well.

Can you check the DXF, when I open it in my CAD package all I get is one horizontal line? ____________________________

[John S]

Can you check the DXF, when I open it in my CAD package all I get is one horizontal line? ____________________________

Same here,
I'll bet this was done in Turbocad ?

That's a classic export move of theirs.

.

[lateAtNight]

Dammit!

It was exported from Rhino, but I did the work in Maya.

I opened the dxf in Rhino and its all there. However I opened it up in eDrawings viewer as well, and its like you said.

Can you open .IGES? Its attached... and in a zip because the site won't let me upload an iges.

What sizes of the black cable tidy stuff have you got?

[Ccrewz]

I have 2 boxes under my machine and I would prefer to have a setup similar to what you have down.
I would sure like to see the build log for that PC/controller Lee.
Any chance of you posting a build log?
Thanks, Keith