Poorly N sick Fadal 15 VMC Will live again!

[JAZZCNC]

I am in the process of buying a controller similar to the on you have purchased, but mine will be for a lathe and use stepper drives.
When i asked Eileen about panel c with the MPG she said it could not be used at the same time as the hand MPG. I tried to rephrase it but got the same reply.
Did you confirm that there was some way the hand MPG option could be used? Is it possible to buy a machine cabinet socket to connect to the panel, and plug the mpg into that socket?
Thanks
Colin

Hi Colin,

My Manual says it can use Both at the same time but I've not tried it yet and it may be different for Lathe.? I've just set the controller up on the bench and I'll be posting a vid soon and then will post more as I get time.
I'll try to find time to plug the pendant and test it for you.

Regards the Mains Voltage on the Front panel you mentioned in your PM (sorry i forgot to reply) there isn't any mains voltage on the panel other than the 24V psu. The Start/stop buttons are not connected to anything and I will using these to control contactors etc with 24Vdc so No mains voltage will be on the panel.

[JAZZCNC]

Just a quick update Vid of it on the bench for testing. If people are interested I'll post more Vids.

[Colin Barron]

Hi Colin,

My Manual says it can use Both at the same time but I've not tried it yet and it may be different for Lathe.? I've just set the controller up on the bench and I'll be posting a vid soon and then will post more as I get time.
I'll try to find time to plug the pendant and test it for you.

Regards the Mains Voltage on the Front panel you mentioned in your PM (sorry i forgot to reply) there isn't any mains voltage on the panel other than the 24V psu. The Start/stop buttons are not connected to anything and I will using these to control contactors etc with 24Vdc so No mains voltage will be on the panel.

Hi, i should have realised that the panel is 24v, he must have been referring to other machine buttons. I asked the question again about the MPG and as you say it can be used. Very interesting setup video.
Thanks
Colin

[JAZZCNC]

Hi, i should have realised that the panel is 24v, he must have been referring to other machine buttons.

I think Hood was talking about how the Chinese show to wire it in the manual.?

[JAZZCNC]

Another video that will make you laugh at my Stupidity...