. .

Threaded View

Previous Post Previous Post   Next Post Next Post
  1. 19-12-2019 #6
    Doddy's Avatar
    Lives in Preston, United Kingdom.
    Doddy
    Last Activity: 27-04-2025 Has been a member for 9-10 years. Has a total post count of 1,364. Received thanks 188 times, giving thanks to others 66 times. Referred 1 members to the community.
    All good suggestions, I've just thrown one control box out that was home-made/formed from sheet steel - to the limits of my bender (90mm). That was not deep enough when I replaced my baby drivers with slightly larger drivers (TB6600s?, can't remember and not close enough to check) I wouldn't recommend any cabinet less that 200mm depth.
    Reply With Quote Reply With Quote

  2. The Following User Says Thank You to Doddy For This Useful Post:

« Previous Thread | Next Thread »

Thread Information

Users Browsing this Thread

There are currently 1 users browsing this thread. (0 members and 1 guests)

Similar Threads

  1. Enclosure Recommendations
    By Washout in forum Control Hardware & Systems
    Replies: 1
    Last Post: 20-05-2021, 12:45 PM
  2. CNC router enclosure
    By Leadhead in forum Workshop & Equipment
    Replies: 2
    Last Post: 03-05-2018, 11:00 PM
  3. Help on building an enclosure
    By thomashomer1986 in forum General Electronics
    Replies: 12
    Last Post: 02-02-2014, 06:38 PM
  4. PCB enclosure ?
    By manofgresley in forum Electronic Project Building
    Replies: 15
    Last Post: 10-08-2012, 11:47 AM
  5. Stepper shaft size and pulley bore size problem
    By psiron in forum Linear & Rotary Motion
    Replies: 13
    Last Post: 15-06-2010, 04:11 PM

Bookmarks

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  

Forum Rules