Quote Originally Posted by Juranovich View Post
Moving on to the mechanical side of things (at least for now) and essentially the gantry arm design. Am I right in assuming that it is the centre of gravity of the entire gantry assembly (incl. gantry arms, beam, z-axis, spindle etc.) that preferably should be half way between the X-axis (long axis) rail carriages?
Yes Ideally but again without wanting to sound like a broken record don't let these kinds of details bog you down from the building phase. The COG being off a little like what your showing isn't going to make one jot of difference to how the machine performs or how it affects component life in a DIY environment.

Anyone who's built a machine and worried about these kinds of things will tell you that it was a pointless exercise and it's the smaller details that make a bigger difference to how the machine performs. Details like sturdy ball-nut brackets and adjustability, motor mounts, wire routing, Limit SW placement, access to grease nipples and lubing, etc, etc.
If you build a Sturdy structure and pay attention to key areas like Z-axis then you won't go wrong or notice if COG is off a little, but you will notice if the little details are missed.

My advice is to look around at other builds and pay more attention to the little details and pay less attention to if COG looks a little offset.!