-
28-03-2020 #21
-
28-03-2020 #22
Jazz thanks for that i will go out to the shop and check these yes the relays come from VW
-
28-03-2020 #23
ok i have 240v going in but nothing on the output so it looks like the unit is dead goes with the led not lighting up out of interest what normal goes on these psu
once again many thanks for your help Geoff
-
Yes. If you get them the wrong way round it will just measure -ve. make sure the meter is set to DC and AC for the mains side. Be careful .
Edit: I had not refreshed by browser so didn't see Jazz post.. Just to make sure that there is not a short on the output make a good pic. and remove all the wires on the DC side and check again.Last edited by Clive S; 28-03-2020 at 12:09 PM.
..Clive
The more you know, The better you know, How little you know
-
28-03-2020 #25
-
28-03-2020 #26
hi Jazz
i will check to see if there is a fuse but something must have blown as you say might just as well get a new one at that price will let you know how i get on
Geoff
-
28-03-2020 #27
-
28-03-2020 #28
-
Here you go:- https://www.ebay.co.uk/itm/Regulated...Nrg9qr7WY2EZng
..Clive
The more you know, The better you know, How little you know
-
28-03-2020 #30
May be worth going for a bigger wattage. These don't fail very often imo. See how much is connected to it.
Mine only powers the 12v-24v part of my BOB and that's it, but I still stuck a 24v-60w on there. I can always get a step down unit if I ever need to add a 12v line.
So with yours being a 12v as long as you get the same voltage unit a bigger current and wattage rating won't matter.
Thread Information
Users Browsing this Thread
There are currently 1 users browsing this thread. (0 members and 1 guests)
Similar Threads
-
mach3 won't reset
By dougberrow in forum Artsoft Mach (3 & 4)Replies: 2Last Post: 27-05-2019, 11:25 PM -
Help needed with Mach 3 - reset external flashing light
By Tom J in forum General ElectronicsReplies: 7Last Post: 26-03-2017, 08:34 PM -
Sieg KX1 & Mach3 won't come out of emergency reset
By lateAtNight in forum Gantry/Router Machines & BuildingReplies: 32Last Post: 19-06-2015, 06:37 PM -
Please help me... It wont work.
By kingcreaky in forum Artsoft Mach (3 & 4)Replies: 12Last Post: 22-01-2014, 10:42 PM
Bookmarks