Hybrid View
-
18-01-2020 #1
thanks for the reply
all the electronics and computer are in the back of the machine when i sited the machine it is against the workshop wall i knew i would need accesses so it means removing the metal shed outside wall and two ton of crap stacked against it will let you no how i get on
Geoff
-
26-03-2020 #2
-
26-03-2020 #3
Tell us exactly what's happening or not, please.
How do you normally start up the machine.? Step by step, so I can get an idea of how it might be wired.
-
26-03-2020 #4
hi Jazz thanks for the reply
first off a lot of the setting up and homing is done with a play station controller
the start up sequence is as followers
switch on 240 at the wall socket
switch on playstation
switch on computer remote button on front control panel of lathe
click mach 3 loader
current profile mach 3 click ok
mach 3 screen
all fires up computer side but cant reset emg stop so icant move forward on homing machine etc
hope this helps thanks Geoff
-
26-03-2020 #5
Erm ok well the PlayStation controller and it's plug-in is a prime suspect because it probably handles the E-stop as well, but I've never used one so not sure on that.
If it was me I'd be disabling the PS controller plug-in to verify it's not this.
However, try this first and see if you get movement. Go into ports n pins then Inputs and look for E-stop. Change the Active Low to the opposite of what it's set to now. ie If a tick toggles it to an (X).
This is basically by-passing the E-stop and tricking Mach3 into thinking it's working, so be careful because you effectively haven't got a E-stop.
If this works then it's either something on the E-stop wiring (or the BOB as blown an Input) or the PS controller or it's Plug-in are broken.
Without knowing a little more about wiring and you tracing wires etc then it's hard to say for certain.
-
26-03-2020 #6
thanks jazz will try this tomorrow not a fan of the play station control but thats what it came with
thanks Geoff
-
26-03-2020 #7
Thread Information
Users Browsing this Thread
There are currently 2 users browsing this thread. (0 members and 2 guests)
Similar Threads
-
mach3 won't reset
By dougberrow in forum Artsoft Mach (3 & 4)Replies: 2Last Post: 27-05-2019, 11:25 PM -
Help needed with Mach 3 - reset external flashing light
By Tom J in forum General ElectronicsReplies: 7Last Post: 26-03-2017, 08:34 PM -
Sieg KX1 & Mach3 won't come out of emergency reset
By lateAtNight in forum Gantry/Router Machines & BuildingReplies: 32Last Post: 19-06-2015, 06:37 PM -
Please help me... It wont work.
By kingcreaky in forum Artsoft Mach (3 & 4)Replies: 12Last Post: 22-01-2014, 10:42 PM
Bookmarks