Trying to get this thing to work

[Doddy]

Photos. Lots of photos.

Trace where the spindle plugs into - either a PCB or a large box - photo. Trace where the motors for the XYZ drives plug into (not just the enclosure, but inside the enclosure where they run to a PCB) - photo. Trace where the computer plugs into the control box - photo.

[GeneO]

I haven't used this or any forum before. Is there a way to see if you have a response at a glance?

[JAZZCNC]

I haven't used this or any forum before. Is there a way to see if you have a response at a glance?

Think you can go to settings and select so sends you a message when a post happens.

[GeneO]

Thanks I'll try.

[GeneO]

I don't know if this picture is going to go thru. If it doesn't I could e mail it to you.