Thread: AXBB-E licence key problem
Threaded View
-
22-01-2020 #3
Last Activity: 07-11-2023
I don't seem to get any error message that I can see, it just starts up in demo mode as if the key wasn't there
. I don't get the profile select thing any more as I've put /d AXBB-E into the shortcut that launches UCCNC
Reply With QuoteThread Information
Users Browsing this Thread
There are currently 1 users browsing this thread. (0 members and 1 guests)
Similar Threads
-
AXBB charge pump fault
By CharlieRam in forum CNCdrive (UC100, UC300ETH)Replies: 78Last Post: 18-07-2021, 08:31 PM -
Help needed to connect my VFD to the AXBB controller
By CharlieRam in forum Spindles & Drive MotorsReplies: 24Last Post: 23-09-2020, 12:10 PM -
CNCDrive AXBB super deal?
By driftspin in forum CNCdrive (UC100, UC300ETH)Replies: 18Last Post: 16-03-2019, 10:10 PM -
Mach 3 new licence, now reset not working..
By Fastesteddy in forum Artsoft Mach (3 & 4)Replies: 7Last Post: 13-07-2018, 07:57 PM -
Mach3 licence
By Duffman in forum Artsoft Mach (3 & 4)Replies: 10Last Post: 22-07-2017, 06:47 PM
Bookmarks