Groping my way forward

[Britannicus1]

You need to use a post processor that is compatible with the machine you are cutting on (if I am reading what the problem is correctly)
If you are using Fusion 360 you should be able to find a PP here ;_
https://cam.autodesk.com/hsmposts

Just ignore this post if you have already done this

Really helpful, thank you so much - I followed this up - but discovered that there is no PP on the fusion site for USBCNC, but now i knew what I was a looking for and found this - just in case anyone else is looking for this

http://hacknorway.com/wordpress/post.../#comment-3108

I really appreciate your help as it's meant that i think I'm finally getting to where i can use my new CNC machine

[needleworks]

Really helpful, thank you so much - I followed this up - but discovered that there is no PP on the fusion site for USBCNC, but now i knew what I was a looking for and found this - just in case anyone else is looking for this

http://hacknorway.com/wordpress/post.../#comment-3108

I really appreciate your help as it's meant that i think I'm finally getting to where i can use my new CNC machine

Hopefully it will work